blob: 04827aaf6c77cec8c4ac0d718cc766b4a4ad046e [file] [log] [blame]
/*
* Copyright (C) 2012 The Android Open Source Project
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#pragma once
__BEGIN_DECLS
#define BTSOCK_FLAG_ENCRYPT 1
#define BTSOCK_FLAG_AUTH (1 << 1)
#define BTSOCK_FLAG_NO_SDP (1 << 2)
#define BTSOCK_FLAG_AUTH_MITM (1 << 3)
#define BTSOCK_FLAG_AUTH_16_DIGIT (1 << 4)
#define BTSOCK_FLAG_LE_COC (1 << 5)
typedef enum {
BTSOCK_RFCOMM = 1,
BTSOCK_SCO = 2,
BTSOCK_L2CAP = 3,
BTSOCK_L2CAP_LE = 4
} btsock_type_t;
/** Represents the standard BT SOCKET interface. */
typedef struct {
short size;
RawAddress bd_addr;
int channel;
int status;
// The writer must make writes using a buffer of this maximum size
// to avoid loosing data. (L2CAP only)
unsigned short max_tx_packet_size;
// The reader must read using a buffer of at least this size to avoid
// loosing data. (L2CAP only)
unsigned short max_rx_packet_size;
} __attribute__((packed)) sock_connect_signal_t;
typedef struct {
/** set to size of this struct*/
size_t size;
/**
* Listen to a RFCOMM UUID or channel. It returns the socket fd from which
* btsock_connect_signal can be read out when a remote device connected.
* If neither a UUID nor a channel is provided, a channel will be allocated
* and a service record can be created providing the channel number to
* create_sdp_record(...) in bt_sdp.
* The callingUid is the UID of the application which is requesting the
* socket. This is used for traffic accounting purposes.
*/
bt_status_t (*listen)(btsock_type_t type, const char* service_name,
const bluetooth::Uuid* service_uuid, int channel,
int* sock_fd, int flags, int callingUid);
/**
* Connect to a RFCOMM UUID channel of remote device, It returns the socket fd
* from which the btsock_connect_signal and a new socket fd to be accepted can
* be read out when connected. The callingUid is the UID of the application
* which is requesting the socket. This is used for traffic accounting
* purposes.
*/
bt_status_t (*connect)(const RawAddress* bd_addr, btsock_type_t type,
const bluetooth::Uuid* uuid, int channel, int* sock_fd,
int flags, int callingUid);
/**
* Set the LE Data Length value to this connected peer to the
* maximum supported by this BT controller. This command
* suggests to the BT controller to set its maximum transmission
* packet size.
*/
void (*request_max_tx_data_length)(const RawAddress& bd_addr);
} btsock_interface_t;
__END_DECLS