sensorservice/1.0/IDirectReportChannel.hal

/*
 * Copyright (C) 2017 The Android Open Source Project
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *      http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */

package android.frameworks.sensorservice@1.0;

import android.hardware.sensors@1.0::RateLevel;

/**
 * The interface represents a direct channel created by
 * ISensorManager.createSharedMemoryDirectChannel() and
 * ISensorMangaer.createHardwareBufferDirectChannel().
 */
interface IDirectReportChannel {

    /**
     * Configure direct report on channel
     *
     * Configure sensor direct report on a direct channel: set rate to value
     * other than STOP so that sensor event can be directly written into the
     * shared memory region used for creating the channel; set rate to STOP will
     * stop the sensor direct report.
     *
     * To stop all active sensor direct report configured to a channel, set
     * sensorHandle to -1 and rate to STOP.
     *
     * @param  sensorHandle handle of the sensor to operate on. If it is -1
     *                      and rate is STOP, the call must stop of all active
     *                      sensor direct report.
     * @param  rate         rate level value to set on the specified sensor.
     *
     * @return result      OK on success;
     *                     BAD_VALUE if parameter is invalid (for example,
     *                     rate level is not supported by sensor, etc);
     *                     INVALID_OPERATION if functionality is not supported.
     * @return token       the token used to distinguish sensor events from
     *                     multiple different sensors of the same type in a
     *                     single direct channel, or 0 if: (1) no such token
     *                     may be returned or (2) error (in which case result
     *                     must be value other than OK).
     */
    configure(int32_t sensorHandle, RateLevel rate)
            generates (int32_t token, Result result);
};