blob: 057ce920809ed04dcd26100e1fdb35da9aaa1e6c [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright (c) 2016 Rockchip Electronics Co., Ltd
*/
#include <common.h>
#include <dm.h>
#include <env.h>
#include <clk.h>
#include <asm/armv7.h>
#include <asm/io.h>
#include <asm/arch-rockchip/bootrom.h>
#include <asm/arch-rockchip/clock.h>
#include <asm/arch-rockchip/cru_rk3288.h>
#include <asm/arch-rockchip/hardware.h>
#include <asm/arch-rockchip/grf_rk3288.h>
#include <asm/arch-rockchip/pmu_rk3288.h>
#include <asm/arch-rockchip/qos_rk3288.h>
#include <asm/arch-rockchip/sdram_common.h>
DECLARE_GLOBAL_DATA_PTR;
#define GRF_BASE 0xff770000
const char * const boot_devices[BROM_LAST_BOOTSOURCE + 1] = {
[BROM_BOOTSOURCE_EMMC] = "dwmmc@ff0f0000",
[BROM_BOOTSOURCE_SD] = "dwmmc@ff0c0000",
};
#ifdef CONFIG_SPL_BUILD
static void configure_l2ctlr(void)
{
u32 l2ctlr;
l2ctlr = read_l2ctlr();
l2ctlr &= 0xfffc0000; /* clear bit0~bit17 */
/*
* Data RAM write latency: 2 cycles
* Data RAM read latency: 2 cycles
* Data RAM setup latency: 1 cycle
* Tag RAM write latency: 1 cycle
* Tag RAM read latency: 1 cycle
* Tag RAM setup latency: 1 cycle
*/
l2ctlr |= (1 << 3 | 1 << 0);
write_l2ctlr(l2ctlr);
}
#endif
int rk3288_qos_init(void)
{
int val = 2 << PRIORITY_HIGH_SHIFT | 2 << PRIORITY_LOW_SHIFT;
/* set vop qos to higher priority */
writel(val, CPU_AXI_QOS_PRIORITY + VIO0_VOP_QOS);
writel(val, CPU_AXI_QOS_PRIORITY + VIO1_VOP_QOS);
if (!fdt_node_check_compatible(gd->fdt_blob, 0,
"rockchip,rk3288-tinker")) {
/* set isp qos to higher priority */
writel(val, CPU_AXI_QOS_PRIORITY + VIO1_ISP_R_QOS);
writel(val, CPU_AXI_QOS_PRIORITY + VIO1_ISP_W0_QOS);
writel(val, CPU_AXI_QOS_PRIORITY + VIO1_ISP_W1_QOS);
}
return 0;
}
int arch_cpu_init(void)
{
#ifdef CONFIG_SPL_BUILD
configure_l2ctlr();
#else
/* We do some SoC one time setting here. */
struct rk3288_grf * const grf = (void *)GRF_BASE;
/* Use rkpwm by default */
rk_setreg(&grf->soc_con2, 1 << 0);
/*
* Disable JTAG on sdmmc0 IO. The SDMMC won't work until this bit is
* cleared
*/
rk_clrreg(&grf->soc_con0, 1 << 12);
rk3288_qos_init();
#endif
return 0;
}
#ifdef CONFIG_DEBUG_UART_BOARD_INIT
void board_debug_uart_init(void)
{
/* Enable early UART on the RK3288 */
struct rk3288_grf * const grf = (void *)GRF_BASE;
rk_clrsetreg(&grf->gpio7ch_iomux, GPIO7C7_MASK << GPIO7C7_SHIFT |
GPIO7C6_MASK << GPIO7C6_SHIFT,
GPIO7C7_UART2DBG_SOUT << GPIO7C7_SHIFT |
GPIO7C6_UART2DBG_SIN << GPIO7C6_SHIFT);
}
#endif
static void rk3288_detect_reset_reason(void)
{
struct rk3288_cru *cru = rockchip_get_cru();
const char *reason;
if (IS_ERR(cru))
return;
switch (cru->cru_glb_rst_st) {
case GLB_POR_RST:
reason = "POR";
break;
case FST_GLB_RST_ST:
case SND_GLB_RST_ST:
reason = "RST";
break;
case FST_GLB_TSADC_RST_ST:
case SND_GLB_TSADC_RST_ST:
reason = "THERMAL";
break;
case FST_GLB_WDT_RST_ST:
case SND_GLB_WDT_RST_ST:
reason = "WDOG";
break;
default:
reason = "unknown reset";
}
env_set("reset_reason", reason);
/*
* Clear cru_glb_rst_st, so we can determine the last reset cause
* for following resets.
*/
rk_clrreg(&cru->cru_glb_rst_st, GLB_RST_ST_MASK);
}
__weak int rk3288_board_late_init(void)
{
return 0;
}
int rk_board_late_init(void)
{
rk3288_detect_reset_reason();
return rk3288_board_late_init();
}
static int do_clock(cmd_tbl_t *cmdtp, int flag, int argc,
char * const argv[])
{
static const struct {
char *name;
int id;
} clks[] = {
{ "osc", CLK_OSC },
{ "apll", CLK_ARM },
{ "dpll", CLK_DDR },
{ "cpll", CLK_CODEC },
{ "gpll", CLK_GENERAL },
#ifdef CONFIG_ROCKCHIP_RK3036
{ "mpll", CLK_NEW },
#else
{ "npll", CLK_NEW },
#endif
};
int ret, i;
struct udevice *dev;
ret = rockchip_get_clk(&dev);
if (ret) {
printf("clk-uclass not found\n");
return 0;
}
for (i = 0; i < ARRAY_SIZE(clks); i++) {
struct clk clk;
ulong rate;
clk.id = clks[i].id;
ret = clk_request(dev, &clk);
if (ret < 0)
continue;
rate = clk_get_rate(&clk);
printf("%s: %lu\n", clks[i].name, rate);
clk_free(&clk);
}
return 0;
}
U_BOOT_CMD(
clock, 2, 1, do_clock,
"display information about clocks",
""
);