| Speex has been ported to the Blackfin DSP, for the STAMP development board. |
| |
| This port has been tested on the STAMP development board and requires the |
| toolchain available at http://blackfin.uclinux.org/ |
| |
| In order to cross-compile for uclinux: |
| export CC=bfin-uclinux-gcc |
| ./configure --enable-blackfin-asm --enable-fixed-point --host=bfin-uclinux |
| make |
| make install |
| |
| The --enable-blackfin-asm option is not required, but it speeds up Speex by |
| approximately a factor of two. |
| |
| If you're getting a crash when enabling --enable-blackfin-asm then your |
| toolchain (assembler in fact) is probably too old (a bug was fixed in the |
| June 3rd build) |