power: supply: cpcap-charger: Limit voltage to 4.2V for battery
There have been some cases of droid4 battery bulging that seem to be
related to being left connected to the charger for several weeks.
It is suspected that the 4.35V charge voltage configured for the battery
is too much in the long run, so lets limit the charge voltage to 4.2V.
It could also be that the batteries are just getting old.
We don't really want to just change the charge voltage to 4.2V as Android
may have charged the battery to 4.35V as pointed out by Pavel Machek.
To add checks for battery voltage, the driver needs to understand the
voltage it's charging at, and also needs to better understand it's
charger state. Right now it only understands connect and disconnect,
while now we need to know also a connected state but not charging.
So let's add better charger state handling with help of chrgcurr2 interrupt
for detecting charge full and retry, and add a check for battery voltage
before we start charging. And then we finally can lower the charge voltage
to 4.2V.
Note that we've been using the same register values as the Android distros
on droid4, so it is suspected that the same problem also exists in Android.
Cc: Pavel Machek <pavel@ucw.cz>
Cc: Rob Herring <robh+dt@kernel.org>
Reported-by: Merlijn Wajer <merlijn@wizzup.org>
Signed-off-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
diff --git a/Documentation/devicetree/bindings/power/supply/cpcap-charger.txt b/Documentation/devicetree/bindings/power/supply/cpcap-charger.txt
index 80bd873..6048f63 100644
--- a/Documentation/devicetree/bindings/power/supply/cpcap-charger.txt
+++ b/Documentation/devicetree/bindings/power/supply/cpcap-charger.txt
@@ -5,7 +5,8 @@
- interrupts: Interrupt specifier for each name in interrupt-names
- interrupt-names: Should contain the following entries:
"chrg_det", "rvrs_chrg", "chrg_se1b", "se0conn",
- "rvrs_mode", "chrgcurr1", "vbusvld", "battdetb"
+ "rvrs_mode", "chrgcurr2", "chrgcurr1", "vbusvld",
+ "battdetb"
- io-channels: IIO ADC channel specifier for each name in io-channel-names
- io-channel-names: Should contain the following entries:
"battdetb", "battp", "vbus", "chg_isense", "batti"
@@ -21,11 +22,13 @@
compatible = "motorola,mapphone-cpcap-charger";
interrupts-extended = <
&cpcap 13 0 &cpcap 12 0 &cpcap 29 0 &cpcap 28 0
- &cpcap 22 0 &cpcap 20 0 &cpcap 19 0 &cpcap 54 0
+ &cpcap 22 0 &cpcap 21 0 &cpcap 20 0 &cpcap 19 0
+ &cpcap 54 0
>;
interrupt-names =
"chrg_det", "rvrs_chrg", "chrg_se1b", "se0conn",
- "rvrs_mode", "chrgcurr1", "vbusvld", "battdetb";
+ "rvrs_mode", "chrgcurr2", "chrgcurr1", "vbusvld",
+ "battdetb";
mode-gpios = <&gpio3 29 GPIO_ACTIVE_LOW
&gpio3 23 GPIO_ACTIVE_LOW>;
io-channels = <&cpcap_adc 0 &cpcap_adc 1
diff --git a/arch/arm/boot/dts/motorola-cpcap-mapphone.dtsi b/arch/arm/boot/dts/motorola-cpcap-mapphone.dtsi
index d1eae47..08bae93 100644
--- a/arch/arm/boot/dts/motorola-cpcap-mapphone.dtsi
+++ b/arch/arm/boot/dts/motorola-cpcap-mapphone.dtsi
@@ -43,11 +43,13 @@
compatible = "motorola,mapphone-cpcap-charger";
interrupts-extended = <
&cpcap 13 0 &cpcap 12 0 &cpcap 29 0 &cpcap 28 0
- &cpcap 22 0 &cpcap 20 0 &cpcap 19 0 &cpcap 54 0
+ &cpcap 22 0 &cpcap 21 0 &cpcap 20 0 &cpcap 19 0
+ &cpcap 54 0
>;
interrupt-names =
"chrg_det", "rvrs_chrg", "chrg_se1b", "se0conn",
- "rvrs_mode", "chrgcurr1", "vbusvld", "battdetb";
+ "rvrs_mode", "chrgcurr2", "chrgcurr1", "vbusvld",
+ "battdetb";
mode-gpios = <&gpio3 29 GPIO_ACTIVE_LOW
&gpio3 23 GPIO_ACTIVE_LOW>;
io-channels = <&cpcap_adc 0 &cpcap_adc 1
diff --git a/drivers/power/supply/cpcap-charger.c b/drivers/power/supply/cpcap-charger.c
index 74258c7..88bbab6 100644
--- a/drivers/power/supply/cpcap-charger.c
+++ b/drivers/power/supply/cpcap-charger.c
@@ -120,6 +120,13 @@
CPCAP_CHARGER_IIO_NR,
};
+enum {
+ CPCAP_CHARGER_DISCONNECTED,
+ CPCAP_CHARGER_DETECTING,
+ CPCAP_CHARGER_CHARGING,
+ CPCAP_CHARGER_DONE,
+};
+
struct cpcap_charger_ddata {
struct device *dev;
struct regmap *reg;
@@ -138,6 +145,8 @@
atomic_t active;
int status;
+ int state;
+ int voltage;
};
struct cpcap_interrupt_desc {
@@ -153,6 +162,7 @@
bool chrg_se1b;
bool rvrs_mode;
+ bool chrgcurr2;
bool chrgcurr1;
bool vbusvld;
@@ -422,6 +432,7 @@
s->chrg_se1b = val & BIT(13);
s->rvrs_mode = val & BIT(6);
+ s->chrgcurr2 = val & BIT(5);
s->chrgcurr1 = val & BIT(4);
s->vbusvld = val & BIT(3);
@@ -434,6 +445,79 @@
return 0;
}
+static void cpcap_charger_update_state(struct cpcap_charger_ddata *ddata,
+ int state)
+{
+ const char *status;
+
+ if (state > CPCAP_CHARGER_DONE) {
+ dev_warn(ddata->dev, "unknown state: %i\n", state);
+
+ return;
+ }
+
+ ddata->state = state;
+
+ switch (state) {
+ case CPCAP_CHARGER_DISCONNECTED:
+ status = "DISCONNECTED";
+ break;
+ case CPCAP_CHARGER_DETECTING:
+ status = "DETECTING";
+ break;
+ case CPCAP_CHARGER_CHARGING:
+ status = "CHARGING";
+ break;
+ case CPCAP_CHARGER_DONE:
+ status = "DONE";
+ break;
+ default:
+ return;
+ }
+
+ dev_dbg(ddata->dev, "state: %s\n", status);
+}
+
+int cpcap_charger_voltage_to_regval(int voltage)
+{
+ int offset;
+
+ switch (voltage) {
+ case 0 ... 4100000 - 1:
+ return 0;
+ case 4100000 ... 4200000 - 1:
+ offset = 1;
+ break;
+ case 4200000 ... 4300000 - 1:
+ offset = 0;
+ break;
+ case 4300000 ... 4380000 - 1:
+ offset = -1;
+ break;
+ case 4380000 ... 4440000:
+ offset = -2;
+ break;
+ default:
+ return 0;
+ }
+
+ return ((voltage - 4100000) / 20000) + offset;
+}
+
+static void cpcap_charger_disconnect(struct cpcap_charger_ddata *ddata,
+ int state, unsigned long delay)
+{
+ int error;
+
+ error = cpcap_charger_set_state(ddata, 0, 0, 0);
+ if (error)
+ return;
+
+ cpcap_charger_update_state(ddata, state);
+ power_supply_changed(ddata->usb);
+ schedule_delayed_work(&ddata->detect_work, delay);
+}
+
static void cpcap_usb_detect(struct work_struct *work)
{
struct cpcap_charger_ddata *ddata;
@@ -447,24 +531,67 @@
if (error)
return;
+ /* Just init the state if a charger is connected with no chrg_det set */
+ if (!s.chrg_det && s.chrgcurr1 && s.vbusvld) {
+ cpcap_charger_update_state(ddata, CPCAP_CHARGER_DETECTING);
+
+ return;
+ }
+
+ /*
+ * If battery voltage is higher than charge voltage, it may have been
+ * charged to 4.35V by Android. Try again in 10 minutes.
+ */
+ if (cpcap_charger_get_charge_voltage(ddata) > ddata->voltage) {
+ cpcap_charger_disconnect(ddata, CPCAP_CHARGER_DETECTING,
+ HZ * 60 * 10);
+
+ return;
+ }
+
+ /* Throttle chrgcurr2 interrupt for charger done and retry */
+ switch (ddata->state) {
+ case CPCAP_CHARGER_CHARGING:
+ if (s.chrgcurr2)
+ break;
+ if (s.chrgcurr1 && s.vbusvld) {
+ cpcap_charger_disconnect(ddata, CPCAP_CHARGER_DONE,
+ HZ * 5);
+ return;
+ }
+ break;
+ case CPCAP_CHARGER_DONE:
+ if (!s.chrgcurr2)
+ break;
+ cpcap_charger_disconnect(ddata, CPCAP_CHARGER_DETECTING,
+ HZ * 5);
+ return;
+ default:
+ break;
+ }
+
if (!ddata->feeding_vbus && cpcap_charger_vbus_valid(ddata) &&
s.chrgcurr1) {
int max_current;
+ int vchrg;
if (cpcap_charger_battery_found(ddata))
max_current = CPCAP_REG_CRM_ICHRG_1A596;
else
max_current = CPCAP_REG_CRM_ICHRG_0A532;
+ vchrg = cpcap_charger_voltage_to_regval(ddata->voltage);
error = cpcap_charger_set_state(ddata,
- CPCAP_REG_CRM_VCHRG_4V35,
+ CPCAP_REG_CRM_VCHRG(vchrg),
max_current, 0);
if (error)
goto out_err;
+ cpcap_charger_update_state(ddata, CPCAP_CHARGER_CHARGING);
} else {
error = cpcap_charger_set_state(ddata, 0, 0, 0);
if (error)
goto out_err;
+ cpcap_charger_update_state(ddata, CPCAP_CHARGER_DISCONNECTED);
}
power_supply_changed(ddata->usb);
@@ -524,7 +651,7 @@
"chrg_det", "rvrs_chrg",
/* REG_INT1 */
- "chrg_se1b", "se0conn", "rvrs_mode", "chrgcurr1", "vbusvld",
+ "chrg_se1b", "se0conn", "rvrs_mode", "chrgcurr2", "chrgcurr1", "vbusvld",
/* REG_INT_3 */
"battdetb",
@@ -625,6 +752,7 @@
return -ENOMEM;
ddata->dev = &pdev->dev;
+ ddata->voltage = 4200000;
ddata->reg = dev_get_regmap(ddata->dev->parent, NULL);
if (!ddata->reg)
