serial: 8250_lpss: add fractional divisor support
For Synopsys DesignWare 8250 uart which version >= 4.00a, there's a
valid divisor latch fraction register.
Now the preparation is done, it's easy to add the feature support.
This patch firstly tries to get the fractional divisor width during
probe, then setups specific get_divisor() and set_divisor() hook.
Among other changes the FIFO size is now retrieved from the hardware.
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Reviewed-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Link: https://lore.kernel.org/r/20190806094322.64987-6-andriy.shevchenko@linux.intel.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/8250/8250_lpss.c b/drivers/tty/serial/8250/8250_lpss.c
index 3bf2377..0c6aa99 100644
--- a/drivers/tty/serial/8250/8250_lpss.c
+++ b/drivers/tty/serial/8250/8250_lpss.c
@@ -113,7 +113,6 @@
static int byt_serial_setup(struct lpss8250 *lpss, struct uart_port *port)
{
struct dw_dma_slave *param = &lpss->dma_param;
- struct uart_8250_port *up = up_to_u8250p(port);
struct pci_dev *pdev = to_pci_dev(port->dev);
unsigned int dma_devfn = PCI_DEVFN(PCI_SLOT(pdev->devfn), 0);
struct pci_dev *dma_dev = pci_get_slot(pdev->bus, dma_devfn);
@@ -139,10 +138,6 @@
param->m_master = 0;
param->p_master = 1;
- /* TODO: Detect FIFO size automaticaly for DesignWare 8250 */
- port->fifosize = 64;
- up->tx_loadsz = 64;
-
lpss->dma_maxburst = 16;
port->set_termios = byt_set_termios;
@@ -316,6 +311,8 @@
if (ret)
return ret;
+ dw8250_setup_port(&uart.port);
+
ret = lpss8250_dma_setup(lpss, &uart);
if (ret)
goto err_exit;
