drm/amd/display: Adjust stream enable sequence
[Why]
We observed an issue where a display would not accept programming of
the ignore_MSA_timing_param bit if the stream was blanked.
[How]
move enable_stream_features from enable_link_dp to
core_link_enable_stream, after unblank_stream
Signed-off-by: Joshua Aberback <joshua.aberback@amd.com>
Reviewed-by: Jun Lei <Jun.Lei@amd.com>
Acked-by: Anthony Koo <Anthony.Koo@amd.com>
Acked-by: Bhawanpreet Lakha <Bhawanpreet.Lakha@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
diff --git a/drivers/gpu/drm/amd/display/dc/core/dc_link.c b/drivers/gpu/drm/amd/display/dc/core/dc_link.c
index fe557e7..abcfc05 100644
--- a/drivers/gpu/drm/amd/display/dc/core/dc_link.c
+++ b/drivers/gpu/drm/amd/display/dc/core/dc_link.c
@@ -1396,8 +1396,6 @@
else
status = DC_FAIL_DP_LINK_TRAINING;
- enable_stream_features(pipe_ctx);
-
return status;
}
@@ -2594,6 +2592,9 @@
core_dc->hwss.unblank_stream(pipe_ctx,
&pipe_ctx->stream->sink->link->cur_link_settings);
+ if (dc_is_dp_signal(pipe_ctx->stream->signal))
+ enable_stream_features(pipe_ctx);
+
dc_link_set_backlight_level(pipe_ctx->stream->sink->link,
pipe_ctx->stream->bl_pwm_level,
0,
