| # Global settings |
| # Set this to your country code. |
| DAHDI_ZONE=za |
| DAHDI_ECHOCAN=oslec # mg2,jpah,kb1,sec,sec2 (there may be more, we recommend oslec) |
| |
| # Settings for analog |
| #Analog signal types, one of: |
| # ks - KewlStart (recommended, default) |
| # ls - LoopStart |
| # gs - GroundStart |
| |
| # Signalling to be used on FXO ports |
| DAHDI_FXO_SIGNALLING=ks |
| |
| # Signalling to be used on FXS ports |
| DAHDI_FXS_SIGNALLING=ks |
| |
| # Whether or not to echocan: |
| DAHDI_FXO_ECHOCAN=yes |
| DAHDI_FXS_ECHOCAN=yes |
| |
| # These settings will be used for BRI cards. |
| # Known options: B8ZS,AMI,HDB3 |
| DAHDI_BRI_CODING=AMI |
| |
| # Known options: ESF,D4,CCS,CRC4 |
| DAHDI_BRI_FRAMING=CCS |
| |
| # Our experience is that it's not required (still defaults to yes) |
| DAHDI_BRI_NT_ECHOCAN=yes |
| DAHDI_BRI_TE_ECHOCAN=yes |
| |
| # These settings are for PRI cards. Note that only E1 currently supported. |
| DAHDI_E1_CPE_ECHOCAN=yes |
| DAHDI_E1_NET_ECHOCAN=yes |
| |
| # PRI will default to CPE mode (remote end provides signalling). |
| # If you really want to provide signalling set the appropriate spans |
| # here (eg, set span 1 to NET mode). |
| #PRI_SPAN_1_NET=yes |
