| MSM Generic Serial Interface Infrared (GENI-IR) Controller |
| |
| Required properties: |
| - compatible : Should be "qcom,msm-geni-ir" |
| - reg : Offset and length of the register region for the device |
| - reg-names : Register region name referenced in 'reg' above |
| The only required register resource entry is: |
| "base" : GENI-IR controller register block |
| - interrupts : Interrupt numbers used by this controller |
| - interrupt-names : Interrupt resource names referenced in 'interrupts' above |
| Required interrupt resource entries are: |
| "geni-ir-core-irq" : GENI-IR core interrupt |
| "geni-ir-wakeup-irq" : GENI-IR wakeup interrupt |
| - qcom,geni-ir-gpio-tx : GPIO pin number of the GENI-IR transmit line |
| - qcom,geni-ir-gpio-rx : GPIO pin number of the GENI-IR receive line |
| |
| Aliases : |
| Aliases may be optionally used for GENI-IR devices on a target. |
| The alias will have the following format: |
| 'geni_ir{n}' where n is the instance number. |
| |
| GENI-IR device is the child device of the SPSS device. |
| |
| Example: |
| aliases { |
| geni_ir1 = &geni_ir_1; |
| }; |
| |
| qcom,msm-spss@fc5c3000 { |
| |
| ... |
| |
| geni_ir_1: qcom,msm-geni-ir@fc5c1000 { |
| compatible = "qcom,msm-geni-ir"; |
| reg-names = "base"; |
| reg = <0xfc5c1000 0x1000>; |
| interrupts = <0 284 0>, <0 285 0>; |
| interrupt-names = "geni-ir-core-irq", |
| "geni-ir-wakeup-irq"; |
| qcom,geni-ir-gpio-tx = <&msmgpio 8 0>; |
| qcom,geni-ir-gpio-rx = <&msmgpio 9 0>; |
| }; |
| }; |
