ARM: dts: msm: optimize Nemo panel tear check configuration
This helps to avoid the janky state, when refreshing the screen at
60fps leads to waiting for the vsync to swap buffers on every frame.
Change-Id: I1f9399a6ca6118ffc3bd3573367f64710b2cbae5
diff --git a/arch/arm/boot/dts/msm8926-nemo/msm8926-nemo-panel.dtsi b/arch/arm/boot/dts/msm8926-nemo/msm8926-nemo-panel.dtsi
index faeccce..915da12 100644
--- a/arch/arm/boot/dts/msm8926-nemo/msm8926-nemo-panel.dtsi
+++ b/arch/arm/boot/dts/msm8926-nemo/msm8926-nemo-panel.dtsi
@@ -144,7 +144,7 @@
qcom,mdss-dsi-te-pin-select = <1>;
qcom,mdss-dsi-te-v-sync-rd-ptr-irq-line = <0x2c>;
qcom,mdss-dsi-te-dcs-command = <1>;
- qcom,mdss-dsi-te-check-enable;
+ /* qcom,mdss-dsi-te-check-enable; */
qcom,mdss-dsi-te-using-te-pin;
qcom,mdss-dsi-panel-timings = [76 18 10 00 3C 40 14 1C 12 03 04 00];
qcom,mdss-dsi-t-clk-post = <0x04>;
@@ -155,6 +155,8 @@
qcom,mdss-dsi-mdp-trigger = "none";
qcom,mdss-dsi-bl-pmic-control-type = "bl_ctrl_dcs_l";
qcom,mdss-dsi-reset-sequence = <1 50>;
+ /* clk = totlaH * totalV * bpp * 66fps */
+ qcom,mdss-dsi-panel-clockrate = <439922736>;
qcom,mdss-brightness-default-level = <208>;
qcom,cont-splash-enabled;
qcom,ulps-enabled;
