| /* SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause) */ | |
| /* Copyright 2019 NXP */ | |
| #ifndef _FSL_ENETC_MDIO_H_ | |
| #define _FSL_ENETC_MDIO_H_ | |
| #include <linux/phy.h> | |
| /* PCS registers */ | |
| #define ENETC_PCS_LINK_TIMER1 0x12 | |
| #define ENETC_PCS_LINK_TIMER1_VAL 0x06a0 | |
| #define ENETC_PCS_LINK_TIMER2 0x13 | |
| #define ENETC_PCS_LINK_TIMER2_VAL 0x0003 | |
| #define ENETC_PCS_IF_MODE 0x14 | |
| #define ENETC_PCS_IF_MODE_SGMII_EN BIT(0) | |
| #define ENETC_PCS_IF_MODE_USE_SGMII_AN BIT(1) | |
| #define ENETC_PCS_IF_MODE_SGMII_SPEED(x) (((x) << 2) & GENMASK(3, 2)) | |
| #define ENETC_PCS_IF_MODE_DUPLEX_HALF BIT(3) | |
| /* Not a mistake, the SerDes PLL needs to be set at 3.125 GHz by Reset | |
| * Configuration Word (RCW, outside Linux control) for 2.5G SGMII mode. The PCS | |
| * still thinks it's at gigabit. | |
| */ | |
| enum enetc_pcs_speed { | |
| ENETC_PCS_SPEED_10 = 0, | |
| ENETC_PCS_SPEED_100 = 1, | |
| ENETC_PCS_SPEED_1000 = 2, | |
| ENETC_PCS_SPEED_2500 = 2, | |
| }; | |
| struct enetc_hw; | |
| struct enetc_mdio_priv { | |
| struct enetc_hw *hw; | |
| int mdio_base; | |
| }; | |
| #if IS_REACHABLE(CONFIG_FSL_ENETC_MDIO) | |
| int enetc_mdio_read_c22(struct mii_bus *bus, int phy_id, int regnum); | |
| int enetc_mdio_write_c22(struct mii_bus *bus, int phy_id, int regnum, | |
| u16 value); | |
| int enetc_mdio_read_c45(struct mii_bus *bus, int phy_id, int devad, int regnum); | |
| int enetc_mdio_write_c45(struct mii_bus *bus, int phy_id, int devad, int regnum, | |
| u16 value); | |
| struct enetc_hw *enetc_hw_alloc(struct device *dev, void __iomem *port_regs); | |
| #else | |
| static inline int enetc_mdio_read_c22(struct mii_bus *bus, int phy_id, | |
| int regnum) | |
| { return -EINVAL; } | |
| static inline int enetc_mdio_write_c22(struct mii_bus *bus, int phy_id, | |
| int regnum, u16 value) | |
| { return -EINVAL; } | |
| static inline int enetc_mdio_read_c45(struct mii_bus *bus, int phy_id, | |
| int devad, int regnum) | |
| { return -EINVAL; } | |
| static inline int enetc_mdio_write_c45(struct mii_bus *bus, int phy_id, | |
| int devad, int regnum, u16 value) | |
| { return -EINVAL; } | |
| static inline struct enetc_hw *enetc_hw_alloc(struct device *dev, | |
| void __iomem *port_regs) | |
| { return ERR_PTR(-EINVAL); } | |
| #endif | |
| #endif |