| // SPDX-License-Identifier: GPL-2.0 |
| |
| //! Rust PCI driver sample (based on QEMU's `pci-testdev`). |
| //! |
| //! To make this driver probe, QEMU must be run with `-device pci-testdev`. |
| |
| use kernel::{ |
| device::{ |
| Bound, |
| Core, // |
| }, |
| devres::Devres, |
| io::{ |
| register, |
| register::Array, |
| Io, // |
| }, |
| num::Bounded, |
| pci, |
| prelude::*, |
| sync::aref::ARef, // |
| }; |
| |
| mod regs { |
| use super::*; |
| |
| register! { |
| pub(super) TEST(u8) @ 0x0 { |
| 7:0 index => TestIndex; |
| } |
| |
| pub(super) OFFSET(u32) @ 0x4 { |
| 31:0 offset; |
| } |
| |
| pub(super) DATA(u8) @ 0x8 { |
| 7:0 data; |
| } |
| |
| pub(super) COUNT(u32) @ 0xC { |
| 31:0 count; |
| } |
| } |
| |
| pub(super) const END: usize = 0x10; |
| } |
| |
| type Bar0 = pci::Bar<{ regs::END }>; |
| |
| #[derive(Copy, Clone, Debug)] |
| struct TestIndex(u8); |
| |
| impl From<Bounded<u8, 8>> for TestIndex { |
| fn from(value: Bounded<u8, 8>) -> Self { |
| Self(value.into()) |
| } |
| } |
| |
| impl From<TestIndex> for Bounded<u8, 8> { |
| fn from(value: TestIndex) -> Self { |
| value.0.into() |
| } |
| } |
| |
| impl TestIndex { |
| const NO_EVENTFD: Self = Self(0); |
| } |
| |
| #[pin_data(PinnedDrop)] |
| struct SampleDriver { |
| pdev: ARef<pci::Device>, |
| #[pin] |
| bar: Devres<Bar0>, |
| index: TestIndex, |
| } |
| |
| kernel::pci_device_table!( |
| PCI_TABLE, |
| MODULE_PCI_TABLE, |
| <SampleDriver as pci::Driver>::IdInfo, |
| [( |
| pci::DeviceId::from_id(pci::Vendor::REDHAT, 0x5), |
| TestIndex::NO_EVENTFD |
| )] |
| ); |
| |
| impl SampleDriver { |
| fn testdev(index: &TestIndex, bar: &Bar0) -> Result<u32> { |
| // Select the test. |
| bar.write_reg(regs::TEST::zeroed().with_index(*index)); |
| |
| let offset = bar.read(regs::OFFSET).into_raw() as usize; |
| let data = bar.read(regs::DATA).into(); |
| |
| // Write `data` to `offset` to increase `count` by one. |
| // |
| // Note that we need `try_write8`, since `offset` can't be checked at compile-time. |
| bar.try_write8(data, offset)?; |
| |
| Ok(bar.read(regs::COUNT).into()) |
| } |
| |
| fn config_space(pdev: &pci::Device<Bound>) { |
| let config = pdev.config_space(); |
| |
| // Some PCI configuration space registers. |
| register! { |
| VENDOR_ID(u16) @ 0x0 { |
| 15:0 vendor_id; |
| } |
| |
| REVISION_ID(u8) @ 0x8 { |
| 7:0 revision_id; |
| } |
| |
| BAR(u32)[6] @ 0x10 { |
| 31:0 value; |
| } |
| } |
| |
| dev_info!( |
| pdev, |
| "pci-testdev config space read8 rev ID: {:x}\n", |
| config.read(REVISION_ID).revision_id() |
| ); |
| |
| dev_info!( |
| pdev, |
| "pci-testdev config space read16 vendor ID: {:x}\n", |
| config.read(VENDOR_ID).vendor_id() |
| ); |
| |
| dev_info!( |
| pdev, |
| "pci-testdev config space read32 BAR 0: {:x}\n", |
| config.read(BAR::at(0)).value() |
| ); |
| } |
| } |
| |
| impl pci::Driver for SampleDriver { |
| type IdInfo = TestIndex; |
| |
| const ID_TABLE: pci::IdTable<Self::IdInfo> = &PCI_TABLE; |
| |
| fn probe(pdev: &pci::Device<Core>, info: &Self::IdInfo) -> impl PinInit<Self, Error> { |
| pin_init::pin_init_scope(move || { |
| let vendor = pdev.vendor_id(); |
| dev_dbg!( |
| pdev, |
| "Probe Rust PCI driver sample (PCI ID: {}, 0x{:x}).\n", |
| vendor, |
| pdev.device_id() |
| ); |
| |
| pdev.enable_device_mem()?; |
| pdev.set_master(); |
| |
| Ok(try_pin_init!(Self { |
| bar <- pdev.iomap_region_sized::<{ regs::END }>(0, c"rust_driver_pci"), |
| index: *info, |
| _: { |
| let bar = bar.access(pdev.as_ref())?; |
| |
| dev_info!( |
| pdev, |
| "pci-testdev data-match count: {}\n", |
| Self::testdev(info, bar)? |
| ); |
| Self::config_space(pdev); |
| }, |
| pdev: pdev.into(), |
| })) |
| }) |
| } |
| |
| fn unbind(pdev: &pci::Device<Core>, this: Pin<&Self>) { |
| if let Ok(bar) = this.bar.access(pdev.as_ref()) { |
| // Reset pci-testdev by writing a new test index. |
| bar.write_reg(regs::TEST::zeroed().with_index(this.index)); |
| } |
| } |
| } |
| |
| #[pinned_drop] |
| impl PinnedDrop for SampleDriver { |
| fn drop(self: Pin<&mut Self>) { |
| dev_dbg!(self.pdev, "Remove Rust PCI driver sample.\n"); |
| } |
| } |
| |
| kernel::module_pci_driver! { |
| type: SampleDriver, |
| name: "rust_driver_pci", |
| authors: ["Danilo Krummrich"], |
| description: "Rust PCI driver", |
| license: "GPL v2", |
| } |