| # |
| # Copyright 2015 The Android Open Source Project |
| # |
| # Licensed under the Apache License, Version 2.0 (the "License"); |
| # you may not use this file except in compliance with the License. |
| # You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, |
| # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| # See the License for the specific language governing permissions and |
| # limitations under the License. |
| # |
| |
| # Select the SoC |
| $(call set_soc, intel, edison) |
| |
| # Add wifi controller |
| $(call add_peripheral, intel, wifi/bcm43340) |
| # Add bt controller |
| $(call add_peripheral, intel, bluetooth/bcm43340) |
| # Add lights HAL |
| $(call add_peripheral, intel, light/edison_arduino) |
| # Add audio support |
| $(call add_peripheral, intel, audio/edison) |
| # Add sensor support |
| $(call add_peripheral, intel, sensors/edison_arduino) |
| |
| BOARD_SYSTEMIMAGE_PARTITION_SIZE := 268435456 |
| BOARD_USERDATAIMAGE_PARTITION_SIZE := 134217728 |
| BOARD_CACHEIMAGE_PARTITION_SIZE := 268435456 |
| BOARD_U_BOOT_ENV_SIZE := 0x10000 |
| BOARD_GPT_INI := device/intel/edison/gpt.ini |
| |
| |
| PRODUCT_COPY_FILES += \ |
| device/intel/edison/flash_tools/brillo-flashall-edison.sh:provision-device \ |
| device/intel/edison/fstab.device:root/fstab.${soc_name} |
| |
| WIFI_DRIVER_NVRAM_PATH_PARAM := "/sys/module/bcm4334x/parameters/nvram_path" |
| WIFI_DRIVER_FW_PATH_PARAM := "/sys/module/bcm4334x/parameters/firmware_path" |
| |
| WIFI_DRIVER_NVRAM_PATH := "/vendor/firmware/bcm43340/bcmdhd.cal" |
| WIFI_DRIVER_FW_PATH_STA := "/vendor/firmware/bcm43340/fw_bcmdhd_sta.bin" |
| WIFI_DRIVER_FW_PATH_AP := "/vendor/firmware/bcm43340/fw_bcmdhd_apsta.bin" |
| WIFI_DRIVER_FW_PATH_P2P := "/vendor/firmware/bcm43340/fw_bcmdhd_p2p.bin" |
| |
| BOARD_SEPOLICY_DIRS += \ |
| device/intel/edison/sepolicy |
| |
| # Must defined at the end of the file |
| $(call add_device_packages) |