blob: 7867379ca382607c70446c73d854ce7afcf52817 [file] [log] [blame]
/*
* Copyright 2015, The Android Open Source Project
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
/**
* Binder IPC interface for receiving callbacks related to Bluetooth Low Energy
* operations.
*/
oneway interface IBluetoothLowEnergyCallback {
/**
* Called to report the result of a call to
* IBluetoothLowEnergy.registerClient. |status| will be BLE_STATUS_SUCCESS (0)
* if the client was successfully registered. |client_if| is the owning
* application's unique Low Energy client handle and can be used
* to perform further operations on the IBluetoothLowEnergy interface.
*/
void onClientRegistered(in int status, in int client_if);
/* Called asynchronously to notify the delegate of connection state change.
*/
void OnConnectionState(in int status, in int client_id, in const char* address,
in bool connected);
/* Called to report current MTU value. Can be a result of calling
* IBluetoothLowEnergy.setMtu or remote device trying to change MTU.
*/
void OnMtuChanged(in int status, in const char* address, in int mtu);
/**
* Called to report BLE device scan results once a scan session is started for
* this client using IBluetoothLowEnergy.startScan. |scan_result| contains all
* the data related to the discovered BLE device.
*/
void onScanResult(in ScanResult scan_result);
/**
* Called to report the result of a call to
* IBluetoothLowEnergy.startMultiAdvertising or stopMultiAdvertising.
*/
void onMultiAdvertiseCallback(in int status, in boolean is_start,
in AdvertiseSettings settings);
}