blob: b6c87ffaf37e4b196aa4446e5d0e91a45e0d94f4 [file] [log] [blame]
/*
* Copyright (C) 2011 The Android Open Source Project
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#ifndef __CLOCK_RECOVERY_H__
#define __CLOCK_RECOVERY_H__
#include <stdint.h>
#include <common_time/ICommonClock.h>
#include <utils/LinearTransform.h>
#include <utils/threads.h>
#ifdef TIME_SERVICE_DEBUG
#include "diag_thread.h"
#endif
#include "utils.h"
namespace android {
class CommonClock;
class LocalClock;
class ClockRecoveryLoop {
public:
ClockRecoveryLoop(LocalClock* local_clock, CommonClock* common_clock);
~ClockRecoveryLoop();
void reset(bool position, bool frequency);
bool pushDisciplineEvent(int64_t local_time,
int64_t nominal_common_time,
int64_t data_point_rtt);
int32_t getLastErrorEstimate();
// Applies the next step in any ongoing slew change operation. Returns a
// timeout suitable for use with poll/select indicating the number of mSec
// until the next change should be applied.
int applyRateLimitedSlew();
private:
// Tuned using the "Good Gain" method.
// See:
// http://techteach.no/publications/books/dynamics_and_control/tuning_pid_controller.pdf
// Controller period (1Hz for now).
static const float dT;
// Controller gain, positive and unitless. Larger values converge faster,
// but can cause instability.
static const float Kc;
// Integral reset time. Smaller values cause loop to track faster, but can
// also cause instability.
static const float Ti;
// Controller output filter time constant. Range (0-1). Smaller values make
// output smoother, but slow convergence.
static const float Tf;
// Low-pass filter for bias tracker.
static const float bias_Fc; // HZ
static const float bias_RC; // Computed in constructor.
static const float bias_Alpha; // Computed inconstructor.
// The maximum allowed error (as indicated by a pushDisciplineEvent) before
// we panic.
static const int64_t panic_thresh_;
// The maximum allowed error rtt time for packets to be used for control
// feedback, unless the packet is the best in recent memory.
static const int64_t control_thresh_;
typedef struct {
int64_t local_time;
int64_t observed_common_time;
int64_t nominal_common_time;
int64_t rtt;
bool point_used;
} DisciplineDataPoint;
static uint32_t findMinRTTNdx(DisciplineDataPoint* data, uint32_t count);
void reset_l(bool position, bool frequency);
void setTargetCorrection_l(int32_t tgt);
bool applySlew_l();
// The local clock HW abstraction we use as the basis for common time.
LocalClock* local_clock_;
bool local_clock_can_slew_;
// The common clock we end up controlling along with the lock used to
// serialize operations.
CommonClock* common_clock_;
Mutex lock_;
// parameters maintained while running and reset during a reset
// of the frequency correction.
bool last_error_est_valid_;
int32_t last_error_est_usec_;
float last_delta_f_;
int32_t integrated_error_;
int32_t tgt_correction_;
int32_t cur_correction_;
LinearTransform time_to_cur_slew_;
int64_t slew_change_end_time_;
Timeout next_slew_change_timeout_;
// Contoller Output.
float CO;
// Bias tracking for trajectory estimation.
float CObias;
float lastCObias;
// Controller output bounds. The controller will not try to
// slew faster that +/-100ppm offset from center per interation.
static const float COmin;
static const float COmax;
// State kept for filtering the discipline data.
static const uint32_t kFilterSize = 16;
DisciplineDataPoint filter_data_[kFilterSize];
uint32_t filter_wr_;
bool filter_full_;
static const uint32_t kStartupFilterSize = 4;
DisciplineDataPoint startup_filter_data_[kStartupFilterSize];
uint32_t startup_filter_wr_;
// Minimum number of milliseconds over which we allow a full range change
// (from rail to rail) of the VCXO control signal. This is the rate
// limiting factor which keeps us from changing the clock rate so fast that
// we get in trouble with certain HDMI sinks.
static const uint32_t kMinFullRangeSlewChange_mSec;
// How much time (in msec) to wait
static const int kSlewChangeStepPeriod_mSec;
#ifdef TIME_SERVICE_DEBUG
sp<DiagThread> diag_thread_;
#endif
};
} // namespace android
#endif // __CLOCK_RECOVERY_H__