tree 21214ed7e37afff793993703a1e257357d3e6341
parent 7dd6b199df46e871e6e0d0cd7e4f71dc07dfd53c
author Thomas Richter <tmricht@linux.ibm.com> 1574437395 +0100
committer Vasily Gorbik <gor@linux.ibm.com> 1575107566 +0100

s390/cpum_sf: Check for SDBT and SDB consistency

Each SBDT is located at a 4KB page and contains 512 entries.
Each entry of a SDBT points to a SDB, a 4KB page containing
sampled data. The last entry is a link to another SDBT page.

When an event is created the function sequence executed is:

  __hw_perf_event_init()
  +--> allocate_buffers()
       +--> realloc_sampling_buffers()
	    +---> alloc_sample_data_block()

Both functions realloc_sampling_buffers() and
alloc_sample_data_block() allocate pages and the allocation
can fail. This is handled correctly and all allocated
pages are freed and error -ENOMEM is returned to the
top calling function. Finally the event is not created.

Once the event has been created, the amount of initially
allocated SDBT and SDB can be too low. This is detected
during measurement interrupt handling, where the amount
of lost samples is calculated. If the number of lost samples
is too high considering sampling frequency and already allocated
SBDs, the number of SDBs is enlarged during the next execution
of cpumsf_pmu_enable().

If more SBDs need to be allocated, functions

       realloc_sampling_buffers()
       +---> alloc-sample_data_block()

are called to allocate more pages. Page allocation may fail
and the returned error is ignored. A SDBT and SDB setup
already exists.

However the modified SDBTs and SDBs might end up in a situation
where the first entry of an SDBT does not point to an SDB,
but another SDBT, basicly an SBDT without payload.
This can not be handled by the interrupt handler, where an SDBT
must have at least one entry pointing to an SBD.

Add a check to avoid SDBTs with out payload (SDBs) when enlarging
the buffer setup.

Signed-off-by: Thomas Richter <tmricht@linux.ibm.com>
Signed-off-by: Vasily Gorbik <gor@linux.ibm.com>