GPIO: Simplify configuration
Previously there were only two uses of gpio_config_pins, one was
gpio_config_module, which passed in GPIO_CONFIG_ALL_PORTS (the only
place this is used), the other was the common I2C code when it needs to
return the SDA and SCL lines to their alternate function after unwedging
the bus.
These uses are so different that it doesn't make much sense to keep a
single API for them. This change adds a gpio_config_pin that is
simpler to use as it just takes a gpio_signal enum to select the GPIO
to configure and makes gpio_config_pins and GPIO_CONFIG_ALL_PORTS
internal to gpio.c
Signed-off-by: Anton Staaf <robotboy@chromium.org>
BRANCH=None
BUG=None
TEST=make buildall -j
Change-Id: I92bfb0b520b0aa2165655b2ff5076e428c88631f
Reviewed-on: https://chromium-review.googlesource.com/322437
Commit-Ready: Anton Staaf <robotboy@chromium.org>
Tested-by: Anton Staaf <robotboy@chromium.org>
Reviewed-by: Aseda Aboagye <aaboagye@chromium.org>
3 files changed
