| * Neutrino Ethernet * |
| This driver implements Ethernet driver for Neutrino ethernet controller |
| Required properties: |
| - compatible: Should be "qcom,ntn_avb" |
| - ntn-rst-gpio: Neutrino reset GPIO |
| - vdd-ntn-hsic-supply: neutrino HSIC power supply |
| - vdd-ntn-pci-supply: PCIe core power supply |
| - vdd-ntn-io-supply: Neutrino IO power supply |
| - vdd-ntn-phy-supply: Ethernet Phy power supply |
| - vdd-ntn-core-supply: Neutrino core power supply |
| - pinctrl-names: should contain GPIO details |
| - pinctrl-0: Neutrino reset GPIO [this is from MSM] |
| - ntn-rst-delay-msec: dealy (msec) required after PCIe reset for stabilization |
| - ntn-rc-num: PCIe root complex number on which Neutrino is connected |
| Example: |
| qcom,ntn_avb { |
| compatible = "qcom,ntn_avb"; |
| ntn-rst-gpio = <&pm8994_gpios 13 0>; |
| vdd-ntn-hsic-supply = <&pm8994_l25>; |
| vdd-ntn-pci-supply = <&pm8994_s4>; |
| vdd-ntn-io-supply = <&pm8994_s4>; |
| vdd-ntn-phy-supply = <&pm8994_l9>; |
| vdd-ntn-core-supply = <&pm8994_l19>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&ntn_default>; |
| qcom,ntn-rst-delay-msec = <100>; |
| qcom,ntn-rc-num = <1>; |
| }; |
