| config FIQ_DEBUGGER |
| bool "FIQ Mode Serial Debugger" |
| default n |
| depends on ARM || ARM64 |
| help |
| The FIQ serial debugger can accept commands even when the |
| kernel is unresponsive due to being stuck with interrupts |
| disabled. |
| |
| config FIQ_DEBUGGER_NO_SLEEP |
| bool "Keep serial debugger active" |
| depends on FIQ_DEBUGGER |
| default n |
| help |
| Enables the serial debugger at boot. Passing |
| fiq_debugger.no_sleep on the kernel commandline will |
| override this config option. |
| |
| config FIQ_DEBUGGER_WAKEUP_IRQ_ALWAYS_ON |
| bool "Don't disable wakeup IRQ when debugger is active" |
| depends on FIQ_DEBUGGER |
| default n |
| help |
| Don't disable the wakeup irq when enabling the uart clock. This will |
| cause extra interrupts, but it makes the serial debugger usable with |
| on some MSM radio builds that ignore the uart clock request in power |
| collapse. |
| |
| config FIQ_DEBUGGER_CONSOLE |
| bool "Console on FIQ Serial Debugger port" |
| depends on FIQ_DEBUGGER |
| default n |
| help |
| Enables a console so that printk messages are displayed on |
| the debugger serial port as the occur. |
| |
| config FIQ_DEBUGGER_CONSOLE_DEFAULT_ENABLE |
| bool "Put the FIQ debugger into console mode by default" |
| depends on FIQ_DEBUGGER_CONSOLE |
| default n |
| help |
| If enabled, this puts the fiq debugger into console mode by default. |
| Otherwise, the fiq debugger will start out in debug mode. |
| |
| config FIQ_DEBUGGER_UART_OVERLAY |
| bool "Install uart DT overlay" |
| depends on FIQ_DEBUGGER |
| select OF_OVERLAY |
| default n |
| help |
| If enabled, fiq debugger is calling fiq_debugger_uart_overlay() |
| that will apply overlay uart_overlay@0 to disable proper uart. |
| |
| config FIQ_WATCHDOG |
| bool |
| select FIQ_DEBUGGER |
| select PSTORE_RAM |
| default n |